Air-cooled handheld fiber laser welders. No chiller, no water loop, no 3-phase service — plug into 220V single phase and weld. A 600 g gun, wire feed, and adjustable wobble put production-speed welds on stainless, steel, galvanized sheet, brass and aluminum.
Where the benchtop and pedestal systems are built for jewelry and small precision parts, the H-series goes to the work: railings, enclosures, tanks, frames, kitchen and food-service equipment, signage, and general fab shop repair. Welding runs 6 to 10 times faster than TIG, and the seam usually needs little or no cleanup.
Laser power, wobble frequency and wobble length set right on the gun — then a continuous seam weld, start to finish. Specs shown are for the 2500H.
Manufacturer demonstration footage.
Higher power means deeper penetration and faster travel on thicker material. Every model shares the same gun, wire feeder, controls and air-cooled design.
| 1500HLight fab & sheet | 2000HMost popular | 2500HHeaviest sections | |
|---|---|---|---|
| Laser power | 1500 W | 2000 W | 2500 W |
| Wavelength | 1080 ± 5 nm | 1080 ± 5 nm | 1080 ± 5 nm |
| Power supply | 220V ±10%, single phase, 50/60 Hz | 220V ±10%, single phase, 50/60 Hz | 220V ±10%, single phase, 50/60 Hz |
| Machine power draw | 3800 W | 4200 W | 5400 W |
| Welding speed | 0–120 mm/s | 0–120 mm/s | 0–120 mm/s |
| Cooling | Dual-circuit refrigerant direct cooling (air cooled) | Dual-circuit refrigerant direct cooling (air cooled) | Dual-circuit refrigerant direct cooling (air cooled) |
| Shield gas | Nitrogen or argon, 0.3–0.5 MPa | Nitrogen or argon, 0.3–0.5 MPa | Nitrogen or argon, 0.3–0.5 MPa |
| Filler wire | 0.8 / 1.0 / 1.2 / 1.4 / 1.6 mm | 0.8 / 1.0 / 1.2 / 1.4 / 1.6 mm | 0.8 / 1.0 / 1.2 / 1.4 / 1.6 mm |
| Dimensions (L×W×H) | 670 × 480 × 310 mm | 670 × 505 × 310 mm | 670 × 505 × 310 mm |
| Weight | 39 kg / 86 lb | 43 kg / 95 lb | 45 kg / 99 lb |
| Working temperature | −20 to 60 °C | −20 to 60 °C | −20 to 60 °C |
| Quote the 1500H | Quote the 2000H | Quote the 2500H |
Welding gun weighs 600 g. Output is an integrated armored cable plus gun. Machines ship in blue and black; other colors available on request. Pricing and lead time by quote — contact us with your material and thickness.
Stainless, mild steel, carbon steel and galvanized sheet — the everyday fab shop mix.
Fiber wavelength plus wobble handles reflective metals that give TIG operators trouble.
Wobble width and power adjust on the gun, so one machine covers sheet work and heavier sections.
Penetration depends on material, joint fit and travel speed. Send us your part and we will confirm the right power level before you buy.
Tell us your material and thickness and we will size the right H-series machine, with the same US-based install, training and support as every MaxLase system.
